Grizzly G7209 - Manual (Page 18)

-16- G7209/10 14'' Table Saw
2. Set a machinist’s square against the face of
the blade guard/splitter. Slightly rotate the
rear bracket to adjust the face of the blade
guard perpendicular to the table top as
shown in
Figure 13.
Figure 12. Blade guard and splitter in place.
Figure 13. Guard assembly square to table.
Blade Guard/Splitter
1. Slip the blade guard/splitter over the mount-
ing bolts as shown in
Figure 12. The wash-
ers should be between the bolt head and the
slots. Tighten the bolts to secure the blade
guard/splitter.
Your saw comes from the factory with a red motor
bracket designed to protect the motor assembly
during shipping. Remove the bracket shown in
Figure 10C.
4. If the blade guard/splitter is to the right of the
blade as shown in
Figure 15 , simply add
washers between the splitter and front
mounting bracket, and adjust the rear splitter
support as shown in
Figure 16 .
3. Next, set a straightedge against the face of
the saw blade and the blade guard/splitter as
shown in
Figure 14. If the blade guard/split-
ter is properly aligned, please skip ahead to
“Table Insert”; otherwise, continue with the
next step.
Figure 14. Guard in line with blade.
Figure 15. Improper splitter/blade alignment.
Add washers here to move front of
splitter to the left.
Adjust here to move back of splitter
left or right.
Blade
Splitter
Table Surface
The saw blade is extremely sharp. Use extra
care when handling the blade or working
near it. Serious injury is possible.
Guard Support
Blade Guard
Washer
Mounting Bolt