Grizzly H5571 - Manual (Page 8)

The nose of the gun houses a depth
adjustment knob for setting the depth that
the nailer drives nails into the workpiece.
To adjust the depth:
1. If the nail is driven too far into the
workpiece, rotate the knob clockwise
as shown in
Figure 4 )
2. If the nail is not driven far enough into
the workpiece, rotate the knob
counter clockwise.
H5571 34˚ Framing Nailer Kit -7 -
Operating Nailer Adjusting Depth
Figure 4. Depth adjustment knob located
on nailer nose guide.
If you have not read the safety instruc-
tions in this manual, DO NOT operate
the nailer.
Before you operate your nailer, place one
drop of the included oil into the quick con-
nect fitting where the nailer connects to the
air supply.
To operate your nailer:
1. Connect the air supply to the quick
connect fitting.
2. Hold the nailer perpendicular to the
surface of a piece of wood that is thick
enough for the length of nails you
have loaded. Depress the safety yoke
mechanism on your workpiece.
3. Before pressing the trigger, make
sure your free hand is positioned out
of the way of a potential path of a nail
in case of deflection. (Deflection is
caused when the nail changes its
path, resulting in the nail puncturing
the surface of the workpiece as
shown in
Figure 3 .) Deflection can
cause injury if your free hand is secur-
ing the workpiece in the location that
the nail deflects and damage your
workpiece.
Shallower
Deeper
Figure 3. Example of nail deflection.
4. Pull the trigger. If the nail drove into
the wood far enough, continue with
your intended operations. If the nail
either went too far or not far enough,
adjust the depth.