Grizzly H2912/H2913 - Manual (Page 4)

H2912/H2913 2-IN-1 NAILER/STAPLER -3 -
Operating the nailer/stapler can pro-
pel objects into the air, causing
immediate eye damage. To protect
yourself, always wear American
National Standards Institute (ANSI)
approved safety glasses or goggles
when operating this equipment. In
addition, the nailer/stapler dis-
charges at 85-90 decibels. To protect
your hearing, always wear ANSI
approved ear protection when oper-
ating this tool.
Nailer/Stapler Safety
In addition to the rules stated in the previ-
ous section, and those in the warning
boxes throughout this manual, please
observe the following safety tips for your
new nailer/stapler:
1. READ THIS ENTIRE MANUAL
BEFORE OPERATING THE NAIL-
ER/STAPLER.
2. ALWAYS DISCONNECT AIR FROM
THE NAILER/STAPLER
whenever
servicing or installing nails or staples.
During maintenance, a nailer/stapler
connected to air may fire accidentally,
causing serious personal injury.
3. DO NOT PLACE HANDS NEAR
STAPLE OR NAIL POINT OF
ENTRY.
Nails or staples can deflect
and tear through the surface of the
workpiece, puncturing your hand or
fingers.
4. NEVER CONNECT THE
NAILER/STAPLER TO PRESSUR-
IZED OXYGEN OR OTHER COM-
BUSTIBLE GASES
as a power
source. Only use filtered, lubricated,
and regulated compressed air.
5. NEVER USE GASOLINE OR
OTHER FLAMMABLE LIQUIDS TO
CLEAN THE NAILER/STAPLER.
Vapors in the tool will ignite by a
spark and cause the tool to explode.
6. DO NOT CARRY THE NAILER/STA-
PLER BY ANY OTHER PART THAN
THE HANDLE,
and do not carry the
nailer/stapler by the air hose.
7. DO NOT KEEP THE TRIGGER
PULLED ON THE SAFETY YOKE
MECHANISM WHEN CARRYING
OR HOLDING THE TOOL.
8. DO NOT USE A CHECK VALVE OR
ANY OTHER FITTING
that allows air
to remain in the tool .
Never point the nailer/stapler at your-
self or another person! Always pay
attention to the direction the
nailer/stapler is pointed. Use this tool
with respect and caution to lessen the
possibility of operator or bystander
injury. Ignoring this warning may
result in serious personal injury.