Common definitions, terms and phrases – Grizzly G7210 User Manual

Page 9

Advertising
background image

G7209/10 14'' Table Saw

-7-

Common Definitions, Terms and Phrases

The following is a list of common definitions, terms and phrases used throughout this manual as they relate
to this table saw and woodworking in general. It is important that you read and become familiar with them
before assembling, adjusting or operating this machine. Your safety is

VERY

important to us at Grizzly!

Arbor:

Metal shaft extending from the drive

mechanism, to which the cutting blade is
attached.

Bevel Edge Cut:

Tilting the saw arbor and blade

to an angle between 0° and 45° to perform an
angled cutting operation.

Blade Guard:

Metal or plastic mechanism that

mounts over the saw blade to prevent acciden-
tal contact with the cutting edge.

Crosscut:

Table saw operation in which the miter

gauge is used to cut across the grain of a piece
of wood.

Dado Blade:

Blade or set of blades that attach to

the arbor and are used for cutting grooves and
rabbets.

Dado Cut:

Table saw operation that uses a dado

blade to cut a flat bottomed groove into the
face of wood stock.

Featherboard:

Safety device used to keep a

board against the rip fence or table. Allows
operator to keep hands away from the saw
blade.

Kerf:

The resulting cut or gap made by a saw

blade.

Kickback:

A condition in which the wood is

thrown back towards an operator at a high rate
of speed.

Miter Gauge:

A component that controls the

wood stock movement while performing a
crosscut. Allows for variation of angle cuts
such as miter cuts used on a picture frame.

Moulding Head:

A cutterhead attached to the

arbor. Accepts interchangeable moulding
knives for profile cutting. We DO NOT recom-
mend the use of a moulding head as they
require advanced skills in their operation.

Parallel:

Being an equal distance apart at every

point. i.e. the rip fence face is parallel to the
side face of the saw blade.

Non-Thru Cut:

A sawing operation that requires

the removal of the blade guard and splitter.
Dado and rabbet cuts are considered Non-
Thru Cuts because the blade does not pro-
trude above the top face of the wood stock.
Always remember to reinstall the blade guard
and splitter after performing a non-thru cut.

Perpendicular:

Intersecting and forming right

angles; at right angles to the vertical and hori-
zontal planes. i.e. the blade is perpendicular to
the table surface.

Push Paddle:

Safety aid used to push a piece of

wood stock through a cutting operation.

Push Stick:

Safety aid used to push a piece of

wood stock through a cutting operation.
Usually used when rip cutting.

Rabbet:

Cutting operation that creates an L-

shaped channel along the edge of wood stock.

Splitter:

Metal plate attached to the back of the

blade guard that maintains the kerf opening in
the wood when performing a cutting operation.

Standard Kerf:

1

8

" gap made with a standard

blade.

Straightedge:

A tool used to check the flatness,

parallelness, or consistency of a surface(s).

Thru-Sawing:

A sawing operation where the

wood stock thickness is completely sawn
through. Proper blade height usually allows

1

4

"

of the top of the blade to extend above the
wood stock.

Thin Kerf:

3

32

" gap made with a thin kerf blade.

Rip Cut:

A cut made along grain of the wood.

Sacrificial Fence:

A piece of wood attached to

the face of the rip fence that is designed to
extend the fence face away from the metal por-
tion of the fence. Used primarily when making
rabbet cuts with a dado blade.

Advertising