Goodmans 500GB - Manual (Page 9)

Getting started 04
8
Put batteries in the remote control
Open the battery cover of the remote control and put
two AAA size batteries so that the ‘+’ and ‘-’ marks
on the batteries match the ‘+’ and ‘-’ marks inside
the remote control. Replace the battery cover.
1
2
3
Plug in and switch on
Insert the mains lead into the ‘12V DC IN’ on the
back of the Digital TV Recorder and connect the
other end into a mains socket. The red standby
light on the front of the Digital TV Recorder will
come on.
Switch your TV On and select HDMI.
Press the standby button on your remote control.
The first time install screen
The first time installation screen will appear on
screen.
If the signal strength is above 50% press the
[OK] button on your remote control to continue
the setup.
Follow the instructions on screen to complete
the installation.
Step 1 of 5 Step 2 of 5 Step 3 of 5 Step 4 of 5
R Exit Menu
Step 5 of 5
First Time Installation
EXIT OK Search
WARNING !
Make sure that your freesat+ receiver has been connected correctly
before continuing the installation
If signal strength is less than 50%
please check the dish alignment and connections
Network ID Transport ID - - - - - - - -
Press OK to search for the Network and Transport ID
Signal Strength 100% 50% 25% 75%
1 2
abc def
6
mno
8
tuv wxyz
[ . ,
+
+
_
_
AAA Ba
tt
er
y
AAA Ba
tt
er
y