Grizzly H2909 - Manual (Page 7)

H2909 18 Gauge Stapler Kit -6 -
OPERATION
Loading Stapler
Depth Adjustment
Operating Stapler
To load your stapler:
1. Disconnect the air supply from the
stapler!
2. Push the magazine latch in the direc-
tion shown in Figure 1 .
3. Pull back the magazine cover until it
stops.
4. Point the stapler up and insert a stick
of staples into the magazine as shown
in Figure 2 . Make sure that the point-
ed ends of the staples point in the
same direction as the stapler nose
piece.
Figure 1. Releasing magazine latch.
Figure 3. Depth adjustment wheel.
Figure 2. Loading staples into stapler.
5. Push the magazine cover forward
until the magazine latch locks in
place.
1. Rotate the depth adjustment wheel
(shown in
Figure 3 ) clockwise to
increase the nail depth.
2. Rotate the finger wheel counter-clock-
wise to decrease the nail depth.
If you have not read the safety instruc-
tions in this manual, do not operate the
stapler.
Before you operate your stapler, place one
drop of the included oil into the quick con-
nect fitting where the stapler connects to
the air supply. Fire the EMPTY stapler 3-4
times before beginning, so oil does not
come out onto the project during regular
operation.