Garmin zumo 665 - Manual (Page 8)

6 zūmo 665 Owner’s Manual
Getting Started
Connecting the GXM 40 Antenna
to the Automotive Mount
1. With the zūmo placed in the cradle, plug
the GXM 40 antenna into the mini‑USB
port on the back of the automotive mount.
GXM 0
antenna
Mn-USB port
2. Place the GXM 40 antenna within clear
view of the sky.
Mounting Your zūmo on a
Motorcycle
 WarnIng
Incorrectly wiring the power cable with
bare wire leads can result in damage to the
vehicle or the battery and can cause bodily
injury. Garmin strongly recommends having
an experienced installer with the proper
knowledge of electrical systems install the
unit.
See the Important Safety and Product
Information guide in the product box for
product warnings and other important
information.
Do not use the suction cup mount on a
motorcycle.
Step 1: Connecting Power to the
Mount
Select a suitable and secure location to
mount the zūmo on your motorcycle based
on available power sources and safe cable
routing.
Cradle
Headphone/audo out jack (3.5 mm)
Mcrophone
jack (2.5 mm)
Mn-USB connector
(for GXM 0 Antenna)
Bare wres wth
nlne fuse for
power connecton
Power cable
Step 2: Installing the Handlebar
Base
Notice
The recommended torque is 50 lbf-in. Do not
exceed torque of 80 lbf-in.
The zūmo includes parts for two handlebar
installation solutions. Custom mounts can
require additional hardware ( www.ram
-mount.com ).
Option A: Installing the U-bolt and
Handlebar base:
1. Place the U‑bolt around the handlebar,
and thread the ends through the
handlebar base.