GE 29438 - Manual (Page 7)

7
W
ALL
M
OUNT
I
NSTALLATION
1. Remove the mounting bracket from the
back by pressing down on the snap tabs
located at the top, and then lifting it off.
2. Plug the phone line cord into the
phone jack on the back of the unit,
wrap the extra line cord around the
cord wrap on the bottom of the base,
and then thread it through the bottom
of the mounting bracket.
3. Plug the power supply into the POWER
9V DC jack on the back of the unit, and
then thread it through the bottom of
the base.
4. Reverse the direction of the mounting
bracket and replace it by putting the
tabs into the slots on the top of the unit
first, and then snapping the bottom tabs
into place.
5. Connect the phone cord to the modular
jack on the wall.
6. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into
place. (mounting bracket not included.)
7. Connect the DC power supply to an AC
outlet.
8. Rotate the handset hook.
9. Plug the handset cord into the handset
and into the unit, and then hang up the
handset.
FLASH BUSY REDIAL PAUSE REDIAL
CONF
MEMO SET TIMER STORE/I N
TWO LINE DATAPHONE
LOWER
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
MUTE
VOL
SPEAKER
WX YZ 9
MNO 6
DEF 3
#
TUV 8
JKL 5
ABC 2
OPER 0
PQ
RS 7
GHI 4
1
TONE *
line 2
line 1
HOLD
2
3
4
5
6
7
9
8
CAUTION: Use only the ATLINKS USA, Inc. 5-2366 power supply that
came with this unit. Using other adapters can seriously damage the unit.