Giant DX User Manual
Page 5
step 6
step 10
step 7
step 8
step 5
step 4
step 9
Connect the power source plug into an
electric outlet (AC 110~240 volts) and make
sure that all poles are fully inserted into
the socket.
Make sure that the battery is secured in
the “LOCK” position, so that it cannot move
from side to side.
Confirm that LED lamp of the charger
lights up red. The light should remain
constant and not flash. When charging is
finished (which could take approximately
6 hours) the light will go out. The battery
is fully charged.
Disconnect the battery from the charger after the charge is completed.
Unplug the charger’s power source plug from the electrical outlet.
KEEP THE AREA WHERE THE BATTERY IS
CHARGED WELL-VENTILATED AND FREE
FROM LITTER OR ANYTHING ELSE COMBUSTIBLE
TO AVOID FIRE FROM SPARKS OR OVERHEATING!!
DO NOT CHARGE BATTERIES FOR MORE THAN 24 HOURS!!
Place the battery in a horizontal position and
then insert the Twist Freedom charger plug
into the battery’s charging socket.
Lift the battery pack out of its holder.
Mount the battery into its holder.
Step A
Slide the battery pack into its holder at a
45-degree angle. Make sure the “GIANT”
logo on the battery is on the outside of
the bicycle.
Step B
Replace the grip. Gently pivot the battery
pack to an upright position until the battery
pack snaps into place. If the battery
pack does not pivot easily, remove it and
reposition it in the holder and try again.
7
8
caution
caution
Giant
logo
Grip
Step A
Step B