Madge Networks 802.11b - Manual (Page 27)

B-3: Other Problems
100-408-01 Copyright © 2002 Madge Networks. All rights reserved. Page 23
The AP has been set to obtain an IP address automatically by DHCP. How can I know its acquired
IP address so that I can manage it using a Web browser?
Use the utility, Wireless Router/AP Browser (WLBrwsr.exe), in the “AP\Utilities” folder on
the companion CD-ROM disc. This utility can discover nearby advanced APs and show their
MAC addresses and IP addresses. In addition, it can launch the default Web browser on your
computer.
Fig. 27. Wireless Router/AP Browser.
The advanced AP stops working and does not respond to Web management requests.
The firmware of the advanced AP may be stuck in an incorrect state.
Unplug the power connector from the power jack, and then re-plug the connector to
restart the advanced AP.
If the advanced AP still does not work after restarting, there may be hardware component
failures in the advanced AP.
Contact technical support for repair if the unit is in Warranty. Visit www.madge.com/support for more
details.