Micro Technic Micronix RS485 - Manual (Page 2)

Users Manual & Installation Guide
PV- SERIES 4-P ORT RS232/RS422/RS485
Page 2 of 7
D
ESCRIPTION
Micronix PV-interfaces let you customise your system and optimise a combination of RS232, RS422 or RS485
data transmission. All signals are surge protected for industrial applications. The PV-modules plug into any
standard PC/104 bus interface.
With the advanced 16C550 UART or highspeed 16C650 UART (-H versions) with 16-byte FIFO, your
industrial PC can communicate with other computers or peripherals at high speeds.
Compatible to standard serial interfaces supported by DOS and Windows operating systems. Four ribbon
cables with DB-9 connectors are optional.
Non-stackthrough or stackthrough (S-versions) connectors are available.
F
EATURES AND SPECIFICATIONS
♦ Four channels of asynchronous serial communication
♦ Baud rate up to 115 Kbps or 460 Kbps (-H versions)
♦ 16C550 or 16C650 advanced UART with 16-byte FIFO
♦ Supports RS232 interface: TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND
♦ Complete RS-232 Modem control signals, except RI
♦ RTS used for data direction control
♦ Interrupt selectable (IRQ 3,4,5,7,9,10,11,12 or 15)
♦ Individually or shared interrupt
♦ I/O-address selectable from 248H to 3F8H
♦ Surge protection to ± 8 kV according to IEC1000-4-2
♦ Supported by DOS and Windows
♦ Power requirements: +5VDC, 50mA typ, +/- 12VDC, 50mA(except 5V-versions)
♦ Operating temp.: 0 - 60° C
♦ Storage temp.: -20 - 60° C
♦ Relative humidity: 0 - 90%, non-condensing
♦ Dimensions: 95 x 90 x 18 mm
♦ PC/104 Stackthrough connectors (S-versions)
♦ 5V-version for 5V-only systems
♦ Optional cables 10-pin header to DB-9, 20 cm