Melissa 676-001 - Manual (Page 10)

Before using your dehumidifier for the first time, please read this
user guide. We also recommend that you save it in case you need
it at a later point to remind yourself of the device’s functions and
maintenance.
Safety precautions
- Please note that the dehumidifier's voltage is equivalent to the
mains voltage.
- Do not plug in to the mains where other electrical appliances
are already plugged in.
- Use the dehumidifier only for the purpose(s) defined in the
user guide.
- Never insert your fingers, pencils or other objects into the air
intake during operation.
- Switch off before moving or cleaning the device.
- Do not expose to strong heat, as this can cause damage to
the electrical components.
- Do not immerse in any form of liquid.
- Always keep out of the reach of children.
- Do not run the cable under carpets, rugs, etc.
- Ensure the cable is kept away from busy areas to avoid
anyone tripping over it.
- For indoor use only.
- Do not cover. Danger of overheating!
- Do not use if the device or cable become damaged. Take it to
a specialist for repair.
- If the device has been transported in a horizontal position, oil
from the compressor can have leaked into the system. It is
therefore important to let it stand upright for a few hours
before use. This will allow the oil to run back into the
compressor and avoid damage.
The volume of moisture the device can extract from the air
depends on temperature, level of humidity and placing. The
weather outside can also have an effect on how much moisture
can be extracted from the air. In cold weather, the relative humidity
falls causing a corresponding fall in the amount of moisture that
can be extracted.
Key:
1. Operating panel
2. Air intake
3. Water tank (4 litres)
4. Wheels
5. Air exhaust
6. Permanent drain hole
7. Cable winder
8. Cable
Operating panel:
1. Start/stop button
Key to display.
Tank full indicator: lights when the tank is full.
A lamp will light when the device is switched on.
Before use
Find a suitable place close to a mains electricity socket.
The dehumidifier is fitted with for easy manoeuvrability. Caution is
advised in placing the device for operation.
It should not be placed near heating appliances or other heat
sources, or in direct sunlight as this will cause reduced
performance.
Improved performance can be achieved by ensuring the room is
maintained at a temperature over +5C°.
Plug in to a mains plug socket (220-240V ~50Hz)
Ensure that the water tank is positioned correctly, or the
dehumidifier will not start.
If the dehumidifier is to be used near swimming pools or
bathrooms, it must be securely mounted and be connected to
earth.
Installation:
It is important that the device is positioned on a firm level surface
well away from other objects. There must be a minimum distance
of 30 cm from walls or other objects. Do not cover the air exhaust
vent.
-
To start, press the “I/O” button (on/off)
- Full water tank
- The tank-full indicator will light when
the tank is full. The device will switch
off automatically.
- Do not empty the tank while the
device is running. It must be at a
complete standstill before the tank
can be removed.
- When the tank is replaced in the
device, it is ready to operate again.
Permanent drain.
A hose with an internal diameter of 11.5 mm is required for a
permanent drain.( not incl.)
-
Remove the blank on the back of
the device with a screwdriver or
similar implement. Pass the hose
through to the drain nozzle and
secure.
- Ensure there are no kinks in the
hose and that it is not trapped.
Maintenance:
Always remover the plug from the socket before cleaning.
10
UK
1.
2.
3.
4.
5.
6.
7.
8.
1.
MDB-12DMN3_IM 22/12/03 15:47 Side 10