MITSUBISHI ELECTRIC X500 - Manual (Page 10)

EN – 10
Basic connections
This projector can be connected to equipment such as VCRs, video cameras, videodisc players, and personal com-
puters having analog RGB output.
Important:
• Make sure that your equipment is turned off before connection.
• Plug in firmly and unplug by holding the plug, not by pulling the main power cable.
• If connected units are set too close to one another, the image may be affected.
• Refer to the owner's guide of each component for details of connections.
Projector + AV equipment
Important:
• Match the color of video and audio plugs on the AV cable with the connections.
• S-video signals take priority over video signals. If you input both S-video signals and normal video signals at
the same time, the normal video input automatically is inhibited.
REMOTE
AUDIO 2 IN COMPUTER 2 IN
AUDIO OUT COMPUTER OUT
AUDIO 1 IN COMPUTER 1 IN
DIGITAL
ANALOG
INPUT SELECT
MAIN
AC IN
O I
L
R
S-VIDEO VIDEO
AUDIO
VIDEO 1 IN VIDEO 2 IN
USB RS-232C
Connect either one of these.
to S-video input
to S-video output
to video input
to audio input
to video output
to audio output
VCR etc.
REMOTE
AUDIO 2 IN COMPUTER 2 IN
AUDIO OUT COMPUTER OUT
AUDIO 1 IN COMPUTER 1 IN
DIGITAL
ANALOG
INPUT SELECT
MAIN
AC IN
O I
L
R
S-VIDEO
VIDEO
AUDIO
VIDEO 1 IN VIDEO 2 IN
USB RS-232C
B G R
C B (P B ) Y C R (P R )
HD/CS VD
DVD player or HDTV decoder
No connection
BNC - RCA connector
(optional)
Mini D-SUB 15 pin-BNC
conversion cable (optional)
to COMPUTER
AUDIO IN to AUDIO OUT
AUDIO cable
to COMPUTER
IN (Mini D-SUB
15P)
Projector + DVD player or HDTV decoder
Some DVD players have output terminal for 3 line fitting (Y, C
B
, C
R
). When connecting them to the projector,
connect to COMPUTER 1 IN or COMPUTER 2 IN of the projector.
• Y, P
B
, P
R
is an example of the terminal names for a HDTV decoder.
• The terminal name is different depending on the connected equipment.
• Use mini D-SUB 15 pin-BNC conversion cable for connection.
• Some DVD players may not project the image correctly.
• When connecting with HDTV equipment which has R, G, B output, select RGB for the COMPUTER INPUT in
the SIGNAL menu.
• Change the setting in the SIGNAL menu, when 525p signal is inputted. (Refer to pages 29 and 30).
• Set the INPUT SELECT switch on the terminal board to ANALOG. (For X500U only)