Multiquip Mayco Miratron Wireless Remote Control Radio C30HDG - Manual (Page 7)

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 7
RECEIVER INSTALLATION
Parts:
Make sure all parts are accounted for before performing the installation.
The following parts are included with the kit:
Radio Transmitter

Radio Receiver

Spiral Antenna with associated mounting hardware

Coaxial Antenna Cable

Data /Power Cable (7-wire)

Remote Control Cable

Battery Disconnection
Disconnect the negative terminal of the battery cable from the battery. 1.
Ant enna Mounting
Drill a 3/4” hole into the hood on the C30HDG as shown in Figure 1. 1.
After hole has been drilled, deburr hole opening. 2.
Tilt the engine hood slightly forward to gain access to the antenna hole 3.
opening. Support the hood with a block of wood to maintain the desired
access position.
Insert antenna cable thru 3/4” hole opening in hood. Insert BNC end of 4.
cable fi rst.
With one hand holding the antenna end of the cable through the antenna 5.
hole opening, connect the locking fl ange, antenna and rubber gasket.
Tighten locking fl ange securely.
Secure coaxial antenna with pressed on tie-wrap pads (interior). Also 6.
apply pressed on tie-wrap pads (exterior) to the control box support
panel (bottom).