Marmitek LM15 - Manual (Page 5)

ENGLISH
5 LM15 TM
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13 Transceiver or
Marmitek Security Console installed in your house. These components will translate the radio
signals to the Marmitek X-10 signal on the power line. Only one Transceiver should be
installed for all remotes and sensors set to the same House Code.
Am I able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your
remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to
be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power
line before transmitting their data. To prevent your Marmitek X-10 System to become slow or
to prevent dimming from becoming less smooth, make sure that the TM13 units are placed as
far away from each other as possible.
USER INSTRUCTIONS LM15 LAMP MODULE
Compared to most X-10 Modules the LM15 does not have code wheels. The code can be set
up by using any X-10 Controller. Because the LM15 will remember the installed Code even
after a power loss, the LM15 can be set up before it will be installed at its final location (for
instance an outside lamp).
1. Remove your light bulb from its socket and insert the LM15 into the light socket.
2. Insert a light bulb (100W max. open shade, 60W max. closed shade) into the LM15.
3. Set a Marmitek X-10 Controller (f.e. EasyControl8 or IRRF7243) to the required House
and Unit Code.
4. Turn the power off and wait a few seconds.
5. Turn the power back on again.
6. You now can give a new code for the Lamp Socket within 30 seconds. Press the ON
button (corresponding to the Unit Code you want the LM15 to respond to) on the X-10
Controller, 3 times, at about 1 seconds intervals. On the third press the lamp will turn on
signifying that the code has been learned. NOTE: To set the code from an IRRF7243 Mini
Controller press the Unit Code button 3 times.
Technical data
Supply voltage: 230V ±10% 50 Hz
Supply current : < 20 mA capacitive
Switching power: max. 100 W/230V for open shades, max. 60 W/230V for closed
shades. Does not contain a dimmer.
Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz
Input impedance: > 55 Ohm (L - N) at 120 kHz
Ambient temperature: - 10° C to + 50° C (operation) - 20° C to + 70° C (storage)
Dimensions: Ø 46x93 mm
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its
packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product
should be disposed of separately from regular household waste streams. It is your responsibility to dispose
of this and other electric and electronic equipment via designated collection facilities appointed by the gov-
ernment or local authorities. Correct disposal and recycling will help prevent potential negative consequences
to the environment and human health. For more detailed information about the disposal of your old equipment,
please contact your local authorities, waste disposal service, or the shop where you purchased the product.
LM15.qxd 03-11-2006 13:45 Pagina 5