Magic Chef Vissani MCKC490S - Manual (Page 20)

19
Too much foam
If the unit is dispensing too much foam, the problem is most likely caused by either the
unit not being cold enough, or improper pressure to the keg. If the beer is too warm or the
pressure to high or low, there will be excessive foam when dispensed.
Check the liquid temperature in the unit. DO NOT check temperature of first glass of
beer poured, as beer in the hose going up the tower will most likely be warmer than the
beer in the keg.
Make sure there are no CO2 leaks, and that the proper pressure is set on the regulator. It
is recommended to check with the brewer or distributor for proper temperatures and
pressure for each brand, as they can differ. This information can also be found online, at
sites such as
www.micromatic.com .
The beer tower can be kept cooler by inserting foam insulation into the tower.
Make sure the CO2 cylinder valve and the regulator valve are all the way open.
Pull tap handle forward completely and smoothly. Keep glass tipped at an angle until
about ½ full, then start to straighten glass until full.