Metabo PK 300 K - Manual (Page 3)

16
ENG
Scope of Application
This Elektra Precision Circular Saw is designed to perform rip and crosscuts in wood or wooden materials having a square or
rectangular cross section.
- Crosscuts should be performed only with the help of a mitre fence or the Sliding Carriage PK, available as optional accessory.
- Do not crosscut round stock, for ripping use the Square and Round Stock Jig available as optional accessory.
- Maximum saw blade diameter is 300 mm, the minimum blade diameter must be 250 mm.
1 Specifications PK 300 K/4200 DNB
Saw table size 710x900 mm
Table working height 940 mm
Dept of cut at 90
°
/45
°
104/70 mm
Motor speed 2800 rpm
Arbor speed 3800 rpm
Main blade diameter 300 mm
Cutting speed with Ø 300 mm blade 60 mtr/sec
Motor capacity P
1
4200 W-
Motor voltage 3 ~ 400 V
Mains frequency 50/60 Hz
Mains fuse 3 x 16 A time-lag
Suction port diameter 100 mm
Weight 90 kg
Stock-no. 010 300 4209
Noise Emission
The noise emission levels shown below have been established by measuring methods according to:
DIN EN 23 746;
DIN EN 31 202;
ISO 7960 appendix A.
The correction factor K
3
has been established by DIN EN 31204.
1. PK 300 K operating under no load
A-sound pressure level L
pA
74,3 dB(A)
A-sound power level L
WA
87,8 dB(A)
2. PK 300 K operating under load
A-sound pressure level L
pA
84,7 dB(A)
A-sound power level L
WA
98,2 dB(A)
Table of Contents
1 Specifications
2 Standard Delivery
3 Installation
4 Connection to Power Mains
5 Controls/Settings
6 Saw Blades
7 Overview of Components/Terms
8 Jigs and Push Blocks
9 Safety Rules
10 Dust Collection
11 Operation
12 Adjusting the Saw Blade Position
13 Belt Tension
14 Care and Maintenance
15 Wiring Diagrams
16 Optional Accessories
17 Spare Parts Lists
Product Liability/Warranty
We explicitly draw your attention to the fact that, under the current product liability regulations, Elektra Beckum does not have to
assume liability for any damages causes by its products, if such damages result from improper repair, use of replacement parts other
than genuine Elektra parts, or repairs not having been carried out by customer service or authorized service centres.
The three-phase motor of this machine is equipped with an automatically engaging mechanical motor brake, designed for a long
service life. If the braking action fades, and the time to standstill exceeds 10 sec, the brake has to be replaced.
Consult your dealer or authorized service centre.
User Responsibility
This machine will perform in conformity with the description contained tin the instructions provided. This machine must be checked
periodically. Defective equipment (including power cable) should not be used. Parts that are broken, missing, plainly worn, distorted
or contaminated, should be replaced immediately. Should such repair or replacement become necessary, it is recommended that
such repairs are carried out be qualified persons approved by Elektra Beckum or its representative. This machine or any of its parts
should not be altered or changed from standard specifications. The user of this machine shall have the sole responsibility for any
malfunction which results from improper use or unauthorized modification from standard specification, faulty maintenance, damage
or improper repair by anyone other than qualified persons approved by Elektra Beckum or its representative.