Memorex Brush Master Chipper/Shredder with 2-way feed CH2 - Manual (Page 6)

Rev: 07/2010 Brush Master™ Chipper/Shredder with 2-Way Feed
3
Heavy Duty Power Equipment
Component Identification
Recoil Starter
The starter handle
is located on the
engine. Pull the
starter handle to
start engine.
Chipper Funnel
Use the chipper funnel to
feed leaves only.
Chipper Chute
Use the chipper chute to
feed longer and/or thicker
pieces of yard waste into the
impeller for chipping.
Depending on the model #,
the chipper/shredder can cut
up to a 3” x 4” in diameter
piece of wood.
Lawn Tractor or
ATV Hitch
Use this hitch to tow the
chipper/shredder behind
a lawn tractor or ATV
(maximum tow speed is
15 mph).
Discharge Chute
Chipped materials are
discharged through this
opening. It may be left
open or the chipper
collection bag can be
attached to the chute.
Fuel Tank
Use regular unleaded fuel. Always
leave about 1” of air gap at the top
of the tank for fuel expansion to
prevent seepage or spills.
Blade Access Hatch
Remove the blade access
hatch to clean, remove, or
sharpen the chipper/
shredder blade.
Hardware Bag
This bag contains the assembly
hardware, safety devices and
chipper collection bag. Use the
chipper bag to collect shredded or
chipped material fed through the
chipper chute or hopper
assembly.
On/Off Switch
Set this switch to On before
using recoil starter. Set
switch to Off to switch off
engine.
Choke Lever
Move the choke
lever to the CHOKE
position to prepare a
cold engine for
starting.
Fuel Valve
Use the fuel valve
to turn fuel on and
off to engine.
If you are missing any parts, please complete the form on the next page and fax it back to us at: 919-550-3277.
Serial #:
Stamped on engine block
between funnel and engine