Mobile Mark wap11 - Manual (Page 9)

• Passphrase. This is the code used when logging a wireless device onto
the wireless network. It is a text string with a maximum of 16 alphanu-
meric characters. The WEP Key Settings are based upon the Passphrase
determined by you. Type that here. This passphrase may not work with
non-Linksys products due to possible incompatibility with other vendors’
passphrase generators.
8. The following Security Settings screen, shown in Figure 5-7, will allow you
to enter your WEP key. Each point in your wireless network must use the
same WEP key for the network to function properly. Verify that the appro-
priate key is entered and click the Next button to continue or Back to pre-
vious page.
12
Instant Wireless TM Series Wireless Network Access Point
9. The next screen (Figure 5-8) will allow you to review your settings. If these
settings are correct, click the Yes button to save these settings. If there are
any problems with the settings, click the No button and you will return to
the screen shown in Figure 5-2.
10. At this point, the configuration performed with the Setup Wizard is com-
plete, as shown in Figure 5-9. To configure any other Access Points in your
network, you can run this Setup Wizard again. Click the Exit button to exit
the Setup Wizard.
13
Figure 5-9
Figure 5-7
Figure 5-8