Motorola SBV5120 - Manual (Page 14)

Introduction Installation Troubleshooting Glossary License
SBV5120 VoIP Cable Modem User Guide 8
Installation and Configuration
To install and configure your VoIP cable modem for a single PC running Microsoft Windows, we recommend using
the Installation Assistant. You can start the Installation Assistant from the Main Menu on the SURFboard VoIP
Cable Modem CD-ROM. In most cases, the Installation Assistant automatically configures your VoIP cable modem.
Otherwise, to install and configure your VoIP cable modem:
1 Connect the cables as described for your situation:
• “Cabling and Startup for a Single User” on page 8
• “Cabling for Multiple Users” on page 33
2 If you are using the USB port only, go to “Setting Up a USB Driver” on page 10. Ethernet users can skip this
step.
3 Configure TCP/IP and verify the IP address for your computer as described for your situation:
• For Windows computers, see “Configuring TCP/IP” on page 20
• Refer to your Macintosh or UNIX user manual for information regarding TCP/IP and IP address
configuration.
Cabling and Startup for a Single User
Allow some time (5 to 30 minutes) to power up the first time because the SURFboard VoIP cable modem must find
and lock on the appropriate channels for communications.
1 Be sure your computer is on and the VoIP cable modem is unplugged.
2 Connect one end of the coaxial cable to the cable outlet or splitter. Connect the other end of the coaxial cable
to the CABLE connector on the VoIP cable modem. Hand-tighten the connectors to avoid damaging them.
3 Insert the SURFboard VoIP Cable Modem CD-ROM into your CD-ROM drive.
4 If you are using an AC power adapter, plug the adapter into the +12VDC connector on the VoIP cable modem
and an unswitched AC electrical outlet.
or
If you are using an Uninterruptible Power Supply (UPS), plug the power cord into the +12VDC connector on
the VoIP cable modem and into the UPS. Plug the UPS into an unswitched AC electrical outlet.
This turns on the SURFboard VoIP cable modem. You do not need to unplug it when not in use.
To electrical outlet or UPS (step 4)
To cable outlet (step 2)
Always connect coaxial
cable to the wall outlet first.
CABLE
+12VDC
USB
TEL
2
TEL
1
ETHERNET