Multiquip Concrete Saw SP-6457 TD - Manual (Page 36)

36
Setting the Depth Indicator
1. Lower the blade until it just touches the cutting surface.
2. Set the Depth Indicator dial to zero. (The Depth Indicator now accurately
indicates how deep the blade is cutting.)
Setting the Depth Stop
This saw uses a hydraulic Depth Stop to position and lock the blade at the
desired cut depth.
1. Depress SLOW LOWERING button until blade has reached desired cutting
depth.
2. While holding the Slow Lowering button, open the Depth Stop Valve.
3. Close the Depth Stop Valve.
4. Release the SLOW LOWERING button.
5. The saw will now repeatedly lower to the set cutting depth, until the Depth
Stop is re-adjusted.
Fig. 17 — Setting the Depth Gauge and Depth Stop
To disable the Depth Stop when it is not needed:
1. Open the Depth Stop Valve.
2. Set the Blade Collars on the ground.
3. Close the Depth Stop Valve.
CAUTION
Do not cut with the Depth Stop Valve in the OPEN position; this could
cause the blade to rise out of the cut.
Depth Indicator
Depth Stop Valve
Slow Lowering