MACKIE SR1530 - Manual (Page 8)

8
SR1530 SPECIFICATIONS
System Specifications
Frequency Range (–10 dB)
40Hz–20kHz
Frequency Response (–3 dB)
45Hz–18kHz
Horizonal Coverage Angle (–6 dB)
90º averaged 2kHz to
10kHz
Vertical Coverage Angle (–6 dB)
40º averaged 2kHz to
10kHz
Directivity Factor; DI (Q)
10.77 (11.95) averaged
2kHz to 10kHz
Maximum SPL @ 1m 123 dB
Peak Output @ 1m
126 dB
Crossover Points 700Hz, 3000Hz
Dynamic Range > 100 dB
Phase Response ± 40º from 500Hz to
10kHz
Input Type Balanced differential
Input Impedance 50K ohms
Input Protection Monitoring and
limiting of continuous
rms output of amplifiers
Thermal Protection Input stage muting,
auto-reset
Transducer Specifications
Low-Frequency Transducer
Diameter 15˝ (381mm)
Voice Coil Diameter 2.5˝ (63mm)
Power Handling 250W rms (long term) 1
CARE AND
MAINTENANCE
Your Mackie loudspeakers will provide
many years of reliable service if you follow
these guidelines:
Avoid exposing the
loudspeakers to mois-
ture. If they are set up
outdoors, be sure they
are under cover if you
expect rain.
• Avoid exposure to extreme cold (below
freezing temperatures). If you must
operate the loudspeakers in a cold
environment, warm up the voice coils
slowly by sending a low-level signal
through them for about 15 minutes
prior to high-power operation.
• Use a slighty damp cloth with a mild
soap solution to clean the cabinets. Only
do this when the power is turned off.
Avoid getting moisture into any of the
openings of the cabinet, particularly
where the drivers are located.
Mid-Frequency Transducer
Diameter 6˝ (152mm)
Voice Coil Diameter 2˝ (50mm)
Power Handling 60W rms (long term) 1
High-Frequency Transducer
Diaphragm Diameter 1˝ (25mm)
Voice Coil Diameter 1˝ (25mm)
Power Handling 25W rms (long term) 1
Diaphragm Material Mylar
Power Amplifiers
Low-Frequency Power Amplifier
Rated Power 300 watts RMS
Rated THD < 0.05%
Design Class G, High
Efficiency/High Current
Mid and High-Frequency Power Amplifiers
Rated Power 100 watts RMS
Rated THD < 0.1%
Design Integrated Module
Line Input Power
US 120V, 60Hz
Recommended Amperage Service: 8 amps
Europe 230V, 50Hz
Recommended Amperage Service: 5 amps
Physical Properties
Height 43.9˝ (1116mm)
Front Width 19.1˝ (484mm)
Rear Width 13.9˝ (352mm)
Depth 18.1˝ (460mm)
Weight 111.25 lbs. (50.57 kg)
Enclosure Trapezoidal, 10º sides,
18mm multi-layered
plywood, top and bottom
high pressure resin
injected “caps”
Mounting Methods Floor mount only.
The SR1530 should
never be pole-mounted.
The cabinet has no rig-
ging points and is not
suitable for flying.
Never attempt to sus-
pend the cabinet by
its handles.
1 Power handling for transducers is based on an AES long term power test-
ing standard conducted for 100 hours full power, free air.
Disclaimer
Since we are always striving to make our
products better by incorporating new and improved
materials, components, and manufacturing methods,
we reserve the right to change these specifications at
any time without notice.
“Mackie” and the “Running Man” figure are
trademarks or registered trademarks of Mackie
Designs Inc.
All other brand names mentioned are trade-
marks or registered trademarks of their respective
holders, and are hereby acknowledged.
©2002 Mackie Designs Inc.
All Rights Reserved.
Rev. D 03/02