MTD Yard-Man 203 - Manual (Page 8)

8
WARNING: Keep bystanders, helpers,
pets, and children at least 75 feet from the
machine before starting and while
operating. Do not operate this machine
unless the discharge chute and bag have
been properly installed and secured to the
machine.
Stopping Engine
• Move throttle control lever to STOP or OFF
position.
• Disconnect spark plug wire from spark plug and
ground against the engine.
To Empty Bag
The bag is designed to be emptied without being
removed from unit. Open the large zipper in the rear of
the bag to empty the contents. If bag is removed for any
reason, follow the instructions for attaching the bag in
the ASSEMBLY section. Be certain the zipper is closed
completely when operating the unit.
To Engage Drive
To engage the wheel drive, hold the drive clutch control
against the upper handle. Releasing the drive clutch
control stops the rear wheels from driving. Release the
drive clutch control to slow down when negotiating an
obstacle, making a turn, or stopping. Engage control
slowly to prevent the front wheels from lifting up.
Using the Chipper Shredder Vacuum
Place both hands on top of upper handle to push unit
over yard waste. Yard waste such as leaves and pine
needles can be vacuumed up through the nozzle for
shredding. After material has been shredded by the
blades on the impeller assembly, it will be discharged
into catcher bag. Do not attempt to shred or chip any
material other than vegetation found in a normal yard
(i.e. branches, leaves, twigs, etc.) Avoid fibrous plants
such as tomato vines until they are thoroughly dried
out. Materials such as stalks or heavy branches up to 2”
in diameter may be fed into the chipper chute.See
Figure 6.
WARNING: Do not attempt to shred, chip,
or vacuum any material larger than
specified on the machine or in this
manual. Personal injury or damage to the
machine could result.
Figure 6
IMPORTANT: The flail screen is located inside the
housing in the discharge area. If the flail screen
becomes clogged, remove and clean as instructed in
MAINTAINING YOUR CHIPPER SHREDDER
VACUUM. For best performance, it is also important to
keep the chipper blade sharp.
Tire Pressure
(Pneumatic Tires Only)
WARNING: Maximum tire pressure under
any circumstance is 30 psi. Equal tire
pressure should be maintained at all
times.
SECTION 5: ADJUSTING YOUR CHIPPER SHREDDER VACUUM
WARNING: Do not at any time make any
adjustments without first stopping engine,
disconnecting spark plug wire, and
grounding it against the engine. Front Caster Wheels
This chipper shredder vacuum is equipped with front
caster wheels. The casters can be locked in a straight
ahead position or position to swivel freely. Lift and place
pins in the larger holes for locked or straight ahead
operation. Place pins in smaller holes to allow casters
to rotate freely. Lock wheels in straight position when
operating on slopes. See Figure 7.