Muratec IF-200 - Manual (Page 8)

7
2. Installation
2.1. Before You Begin
Remove the IF-200 from the box carefully and remove all packing material. Verify that
you have the following items:
•
IF-200 product
•
AC adapter
•
Telephone line cord
•
Category 5 patch cable
•
Installation Guide and Operation Guide
2.2. Connecting the IF-200
All connections are made on the rear panel of the IF-200. Figure 1 illustrates the real
panel of the IF-200.
TEL
LINE SERIAL FAX
12VAC
1AMP
POWER LAN
LINK ACTV
Figure 1. Rear Panel
CAUTION
Make sure the IF-200 power switch is in the OFF position before making any
connections. To avoid any danger of shock from the telephone line, connect the
telephone line cord to the IF-200 before connecting it to the wall jack. Do not
install this equipment during lightning storms.
2.2.1. First Time Setup
1. If you are using an existing fax machine, unplug the telephone line cord from the
back of the fax machine (the one that goes to the telephone wall jack). Do not touch
the metal contacts on the end of the cord. Now, plug that line cord into the “TEL
LINE” jack on the back of the IF-200.
NOTE: If you are installing your fax machine for the first time, plug the telephone
line cord that came with your fax machine into the “TEL LINE” jack on the
back of the IF-200. Plug the other end of the telephone cord into the RJ-11
telephone wall jack.