Miele G 2143 - Manual (Page 12)

Programming the water
softener
To exit the programming mode at
any time, turn the dishwasher off
with the "
K" button.
^ Turn the dishwasher off with "K".
^ Press and hold the program and
"Start / Stop" button simultaneously
turn the dishwasher on with "
K". Hold
the "Start / Stop" button in until the
"Start / Stop indicator lights.
If it does not come on, start over.
^ Press the "Delay Start" button twice.
The "Delay Start" indicator flashes twice
in intervals and the program sequence
indicator "Rinse" flashes once in
intervals (factory default).
The amount set can be recognized by
the flashing rhythm of the "Rinse"
indicator (see table):
°d gr/gal Flashing rhythm
1 - 4 1 - 4 once
5 - 7 5 - 7 twice
8 - 11 8 - 11 3 times
12 - 15 13 - 16 4 times
16 - 20 17 - 21 5 times
21 - 25 22 - 26 6 times
26 - 30 27 - 31 7 times
31 - 36 32 - 38 8 times
37 - 45 39 - 47 9 times
46 - 70 48 - 73 1 long flash
^ Select the desired setting with the
"Start / Stop" button. Every touch of
the button increases the level.
The programmed dosage is saved.
^ Turn the dishwasher off "s".
Checking the programmed water
hardness level
^ Turn the dishwasher off "K".
^ Press the "Start / Stop" button, at the
same time turn the dishwasher on
"
K".
Hold the "Start / Stop" button in until
the indicator comes on.
^ Press the "Delay Start" button twice.
The "Rinse" indicator flashes in the
rhythm which corresponds to the
adjusted water hardness.
^ Turn the dishwasher off "K".
Before using for the first time
12