17. connecting an optional spool gun – Miller Electric M-10 Gun User Manual
Page 25
Advertising
OM-1330 Page 21
4-17. Connecting An Optional Spool Gun
If a MIG gun is connected to the
unit, remove it before connecting
spool gun.
1
Diverter Valve
.
If spool gun gas hose is
equipped with a pre-installed
barbed fitting, cut off fitting from
end of hose.
Connect spool gun gas hose to
diverter valve barbed fitting (see
Section 4-16).
2
Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
3
Negative (−) Output Terminal
4
Positive (+) Output Terminal
Place toggle switch in Spool Gun
position (see Section 4-16).
Close door.
803 907-B
3
4
2
1
Advertising
This manual is related to the following products: