6. adjusting tension at feeder – Miller Electric OM-227 398D User Manual
Page 14
Advertising
OM-227 398 Page 10
4-5. Threading Welding Wire Through XR-Control Feeder
Ref. 802 193-A
Tools Needed:
2
1
1
Cable Assembly
Lay cable assembly out straight.
2
Jog Switch
Push Jog switch up to feed wire through
cable assembly.
.
Hold wire tightly to keep
it from unraveling.
4-6. Adjusting Tension At Feeder
Ref. 802 193-A
Tools Needed:
Pull and hold wire; cut off end.
6 in
(150 mm)
Open tension arm.
Thread wire thru inlet guide, along drive roll groove, and
into wire conduit. Close tension arm. Adjust tension as
follows: grasp spool with one hand, press Jog switch, and
turn thumb nut clockwise until motor stalls when Jog
switch is pressed. Back thumb nut off slightly.
Advertising