Miele DA 337 I - Manual (Page 31)

5. Position the appliance in
the cabinet
Lift the venting hood into the cabinet,
making sure that the supports on the
venting hood are sitting on the run-
ners in the cabinet. Push it into the
cabinet as far as it will go.
The supports will slide under the anti-
tip device
b .
Insert the adjusting screws c on the
runners through the holes in the sup-
ports.
Use a small screwdriver to push re-
tainer
d down over adjusting screw
c .
6. Align the height of the
appliance
Use screw e to align the height.
Now align the appliance so that it is
horizontal.
Turning screw e clockwise, raises the
appliance upwards, turning it
counterclockwise lowers it.
Close the unit door and check that
the deflector plate goes in and out
smoothly. If necessary make more
adjustments as above.
Installation
31