Makita RBC2510 - Manual (Page 11)

10
To meet the applicable safety provisions, only the tool/ protector combinations as
indicated in the table must be used.
Be sure to use genuine MAKITA cutter blades or nylon cutting head.
– The cutter blade must be well polished, free of cracks or breakage. If the cutter blade hits
against a stone during operation, stop the engine and check the blade immediately.
– Polish or replace the cutter blade every three hours of operation.
– If the nylon cutting head hits against a stone during operation, stop the engine and check the
nylon cutting head immediately.
MOUNTING OF PROTECTOR
– Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).
CAUTION : The appropriate protector must always be installed, for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place is not
permitted.
– When using the string head, fit the protector (6) into the protector (1), and
tighten them with two nuts (5) and two screws (4).
Star Blade Eddy Blade Protector for metal blades
PART NO. 6258507600 PART NO. 6258507700 PART NO. 6258061001
Nylon cutting head Protector for cord cutter
PART NO. 6218016000 PART NO. 6258060001