Magenta MULTIVIEW XR2000 - Manual (Page 16)

16
MAGENTA MULTIVIEW™ SERIES
14
Appendix B. XR2000 Configuration Settings
Note: XR2000 receivers are typically pre-configured at time of order and will have
factory configuration indicated on the bottom of the unit.
The factory configuration may be changed or checked by using the following jumper
location diagram as well as Table B-1 for jumper settings.
Figure B-1. XR2000 Jumper locations.
JP13 controls sync clamping circuitry and has 3 settings depending on the
video signal in use:
RGBHV computer video with separate horizontal and vertical sync == JP13 1-2
Non RGBHV computer video, component RGB/YUV, S-video, composite video
or RGsB video == JP13 2-3
Auto sense video mode == JP13 non-jumpered.