Philips FWC1C37 - Manual (Page 22)

3139 116 19292 (ENG)
22 TIMER SLEEP TIMER
• To exit without storing the setting,
press Ç.
Notes:
– During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
– When a power interruption occurs, the
clock setting is erased.
Timer Setting
• The system can switch on to CD or
TUNER mode automatically at a
preset time. It can serve as an alarm
to wake you up.
• Before setting the timer, make sure
the clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will
increase from the minimum
level to the most recently
selected volume level.
1 Press and hold CLOCK•TIMER
for more than two seconds to
select timer mode.
™ “12:00
AM ” or “ 00:00" or the
last timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
™ The TIMER starts flashing.
™ The selected source is lit while
other available sources are
flashing.
2 Press CD or TUNER to select the
desired source.
• Before selecting CD, make sure a CD
is loaded in the CD carousel tray.
3 Press␣ à or á to set the hour for
the timer to start.
4 Press␣ í or ë to set the minute for
the timer to start.
5 Press CLOCK•TIMER to store
the start time.
™ The timer is now set.
™ The
TIMER remains on the display.
• At the preset time, the timer will be
activated.
™ The selected source will be
played.
Notes:
– During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
– If the source selected is TUNER, the
last tuned frequency will be switched
on.
– If the source selected is CD, playback
will begin with the first track of the
selected disc or program. If the CD
trays are empty, the TUNER will be
selected instead.
– The timer will not activate if a recording
is in progress.
To switch off the TIMER
1 Press and hold CLOCK•TIMER
for more than two seconds.
2 Press Ç on the system to cancel the
timer.
™ The timer is now switched off.
™ The display will show "CANCEL"
and the TIMER disappears.
To start the TIMER again (for the
same preset time and source)
1 Press and hold CLOCK•TIMER
for more than two seconds.
2 Press CLOCK•TIMER again to
store the start time.
™ The timer is now on.
™ The
TIMER appears on the display.
Sleep Timer (only on remote
control)
This feature allows you to select a
length of time after which the system
will switch to the standby mode
automatically.
1 Press SLEEP on the remote control
repeatedly to select a period of time.
™ The selections are as follows (time
in minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™
60 …
™ “SLEEP XX” or “OFF” will be
displayed. " XX" is the time in
minutes.
2 When you reach the desired length
of time, stop pressing the SLEEP
button.
™ After this amount of time passes,
the system will switch to the
standby mode.
To switch off the Sleep Timer
• Press SLEEP repeatedly until "
OFF"
is displayed, or press the
STANDBY ON button.
pg 01-28/C1-C10/37-En 16/11/1999, 1:57 PM 22