Marantz DR6000 - Manual (Page 12)

10
ENGLISH
4 4 4 4 4 With the recorder stopped, press REC TYPE (20) three
times to enter the Manual Record standby mode.
➔ MANUAL starts to flash and the display shows
.
• If message also flashes, the digital con-
nection is incorrect.
5 5 5 5 5 Set the optimal recording level on the CD-Recorder.
q Play the source first to set the optimal recording level on
the CD-Recorder.
w Rotate the EASY JOG (12) key until, on the Record/Play
Level bar, all the white segments are alight, but the red
segments do not light continuously during the loudest
passages.
DIGITAL RECORDING : +6dB ~ –63dB
ANALOG RECORDING : 0dB ~ –63dB
e Stop the source.
6 6 6 6 6 To start recording, press 0 0 0 0 0 REC (13) on the CD-Re-
corder and immediately start the source (from Stop-
mode).
The track number and recording time left appear on the display.
• To record a 3-second silence at the start of a track,
press 2 / ; PLAY/PAUSE (16) on the CD-Recorder
before starting the source.
• To check the elapsed recording time, press DISPLAY
(58) on the CD-Recorder. (This can also be done dur-
ing the recording.)
7 7 7 7 7 To stop recording, press 9 9 9 9 9 STOP (17, 68).
• If 9 STOP (17, 68) was pressed within 3 seconds af-
ter 0 REC (13), no recording will take place.
• To interrupt recording, press 2 / ; PLAY/PAUSE (16)
or ; PAUSE (63).
After recording the display will show for sev-
eral seconds.
Important:
If you want to play the recorded CD-R disc on any regular
CD player, it must first be finalized. See finalizing discs.
Finalized CD-RW discs play only on CD-RW compatible CD
players.
RECORDING
MENU/
STORE CANCEL/
DELETE
0
9 8 7
6 5 4
3 2 1
CD CDR
ABC DEF GHI
JKL MN OPQ
RST UVW XYZ
DISPLAY SPACE SCROLL
FUNCTION
ENTER
Recordable ReWritable
POWER
CD RECORDER DR6000
PLAY/PAUSE STOP
REC
- + PUSH ENTER
EASY JOG
LEVEL PHONES
REC TYPE REW FF
FINALIZE DELETE CANCEL MENU STORE SOURCE ERASE
OPEN/CLOSE
DISPLAY SCROLL
ON/OFF
e r u y t
u
The numbers between parentheses refer to the fold-out.
Manual start recording
Manual recording from external CD player.
1 1 1 1 1 Make sure the disc is absolutely free of scratches and
dust particles.
2 2 2 2 2 Connect the cable from an external CD player to the CD-
Recorder. (see INSTALLATION page 5 and 6.)
3 3 3 3 3 Press SOURCE (7) repeatedly until the selected exter-
nal source appears on the display (depending on the
connection used):
➔ , or lights up and ,
or appears on the display.
About Auto Track increment
• When Auto Track is ON (default setting), track numbers
will automatically be increased during recording.
• To switch off the Auto Track function you have to enter
MENU MODE.
If you wish to increase track numbers manually, press
TRACK INCR(ement) on the remote control. For further
instructions see MENU MODE.
ON (AUTO): The track increments are automatically
taken over from the digital source material
or after 2.7 seconds silence during analog
recording.
OFF (MANUAL): Track numbers can be incremented
manually by pressing TRACK INCR
(ement) (54) on the remote control.
(Minimum track length is 4 sec.)
• Track numbers cannot be changed after recording.
Note:
Auto track works only with Consumer Sources with a digital
output signal according to the IEC 958 (consumer part) audio
standard.
DR6000(U)_Eng_P01-10.p65 8/7/00, 1:35 PM 10