Muratec M F X - 5 5 5 5 - Manual (Page 37)

36 _Loading originals and print media
2. After inserting paper into the tray, while pinching the paper width
guide as shown, move it toward the stack of paper until it lightly
touches the side of the stack. Do not press the guide too tightly to the
edge of the paper; the guide may bend the paper.
When you use legal-sized paper, you need to extend the length of the
tray.
3. Load the paper into the tray.
4. Place the tray into the machine.
5. Set the paper size from your computer.
LOADING PAPER
Loading paper in tray 1, optional tray or optional
high capacity feeder
Load the print media you use for the majority of your print jobs in the tray 1.
The tray 1 can hold a maximum of 520 sheets of 75 g/m
2 (20 lb bond) plain
paper.
You can purchase an optional tray and attach it below the standard tray to
load an additional 520 sheets of paper. (See "Supplies" on page 107.)
1. To load paper, pull and open the paper tray and place paper with the
side you want to print facing down.
2. After loading paper, set the paper type and size for the tray 1. See
"Setting the paper size and type" on page 38 for copying and faxing or
Software section for PC-printing.
• Do not push the paper width guides far enough to cause the
materials to warp.
• If you do not adjust the paper width guides, it may cause paper
jams.
Using photographic paper or coated paper may cause problems,
requiring repairs. Such repairs are not covered by the
warranty or service agreement.
1 Full
2 Empty
Place the side to be printed facing up.
ENVELOPE
PREPRINTED
PAPER
TRANSPARENCY
PUNCHED PAPER CARD STOCK
LETTERHEAD
PAPER
LABEL
• If you experience problems with paper feed, place one sheet at a
time in the multi-purpose tray.
• You can load previously printed paper. The printed side should be
facing up with an uncurled edge at the front. If you experience
problems with paper feed, turn the paper around. Note that print
quality is not guaranteed.