MIDLAND WR-120 Owner Manual - Manual (Page 8)

page 7 www.midlandradio.com
English
François
Español
WR-120 Owner’s Manual
Set Location:
Your WR-120 All Hazards Weather Alert Radio comes preprogrammed to
receive weather and hazard alert transmissions for all S.A.M.E. codes within
range. If this is what you want, leave the radio set to ANY.
“Any” S.A.M.E. Code:
(recommended)
1. Press MENU to open menu options.
2. Press
▲
to scroll through menu to SET LOCATION, then press SELECT.
3. Press
▲
to ANY then press SELECT.
4. Press MENU to exit menu mode.
“Single” S.A.M.E. Code:
1. Press MENU to open menu options.
2. Press
▲
to scroll through menu to SET LOCATION, then press SELECT.
3. Press
▲
to SINGLE then press SELECT.
4. SAME 01 will be displayed. Press SELECT.
5. Use ► ▲ ▼ or
►
to program the 6 digit S.A.M.E. code.
6. Press SELECT.
7. Press MENU to exit menu mode.
Note: In the single mode the last S.A.M.E. code programmed will
be the only one the radio alerts to, even though multiple codes can
be entered in alternate S.A.M.E. positions.
“Multiple” S.A.M.E. Code:
1. Press MENU to open menu options.
2. Press
▲
to scroll through menu to SET LOCATION, then press SELECT.
3. Press
▲
to MULTIPLE then press SELECT.
4. SAME 01 will be displayed. Press SELECT.
5. Use ► ▲ ▼ or
►
to program the 6 digit S.A.M.E. code.
6. Press SELECT.
7. Press
▲
to advance to SAME 02.
8. Repeat steps 4-7 to program up to 25 codes.
9. Press
SELECT.
10. Press MENU to exit menu mode.
Note: While in MENU mode, if no buttons are pressed for
60 seconds, the radio will automatically exit MENU mode.