MITSUBISHI ELECTRIC Diamond View Colour LCD Monitor DV180 - Manual (Page 8)

Installing the Monitor
6
The DV180 monitor is equipped with an auto-sensing power supply that
will operate within the voltage range of 100 to 240 Volts AC, at 50~60 Hz.
3
1. Make sure that the system power
is turned off.
2. Plug the signal cable into the
VGA signal connector at the rear
of the PC.
3. Plug the end of the power cord to
the monitor.
4. Connect the other end of power
cord into the wall socket or other
power source.
5. Turn the monitor on and then turn
the computer on.