M&S Systems WG150W - Manual (Page 8)

installed. Leave at least 18 inches additional ca-
ble for the connection during final speaker instal-
lation. Run the other end of the speaker cable to
the audio source.
NOTE: Make a drawing of each speaker location.
This will assist you in locating the wires if they
have been covered after the wall board has been
installed.
Step 3. This is the finish-out stage. Prepare the
speaker wiring by stripping off approximately 3
inches of the outer jacket (care should be taken
so the insulation on the wires inside the jacket
are not damaged) also strip approximately 3/8
inch off the ends of the two inside conductors.
Twist the ends of the stranded cable so the wires
are tight.
Step 4. Follow the instructions included with the
volume control and amplifier.
Step 5. You are now ready to install the speaker.
Remove the paint mask from the baffle. Be
careful not to touch the speaker cones and
Page 8
Negative (black)
Positive
(red)
FIGURE 3
115986D.pdf 8 115986D.pdf 8 11/16/2005 10:54:35 AM 11/16/2005 10:54:35 AM