Magnadyne DVD/CD Receiver with AM/FM Tuner M3500DVD - Manual (Page 17)

17
Troubleshooting
If the fuse should blow, check that the wiring is
correct. If the wiring is correct, replace the fuse
with the same amperage rating as the original.
Yellow Wire = 15 Amp glass fuse.
Red Wire = 1 Amp glass fuse.
Replaceable Fuses
If it appears that your unit does not operate prop-
erly, first consult this checklist. It may be some-
thing simple which has been overlooked.
Under no circumstances should you try to repair
the player yourself, as this will invalidate the
warranty. Only qualified service personnel can
remove the cover or service this player.
The power does not turn on:
• The lead wires are not connected properly to
the connectors. Make sure the connection is
correct.
• One of the fuses has blown. After checking for
short circuits in the wires, replace the fuse
with one having the same rating.
• The internal processor is not working due to
noise or other factors. Press the reset button to
reset the unit to factory defaults.
The remote control does not work. The unit does
not operate even when the correct buttons on the
remote control are pressed:
• Battery capacity is low. Install new batteries.
• Some operations are disabled in specific
modes. Enter the correct mode.
The disc can not play:
• Disc is of poor quality or damaged or not clean.
Clean or replace the disc with one of higher
quality.
• The disc installed is not supported by the unit.
Examine the disc type.
Disc can not be loaded or ejected:
• Hold the button for 5 seconds to reset the
mechanism. Turn off the unit, and turn on the
unit again.
The desired source is not selected although you
press the MODE button:
• An optional unit required to listen to each
source is not connected yet. Connect the
optional unit correctly.
• The reset button is not pressed yet although the
optional unit has been connected to the unit.
Press the RESET button.