Melissa 644-007 - Manual (Page 10)

10 11
INTRODUCTION
To get the best out of your new appliance, please read this user guide carefully
before using it for the first time. Take particular note of the safety precautions. We
also recommend that you keep the instructions for future reference, so that you can
remind yourself of the functions of your appliance.
SAFETY MEASURES
General
• Incorrect use of this appliance may cause personal injury and damage.
• Use for its intended purpose only. The manufacturer is not responsible for any
injury or damage resulting from incorrect use or handling (see also Guarantee
Terms).
• For domestic use only. Not for outdoor or commercial use.
• For connection to 20 V, 50 Hz only. The appliance must be earthed.
• Do not immerse the motor section, cord or plug in water or any other liquid.
Make sure that no liquid gets into the motor section.
• Never touch the appliance, cord or plug with wet or damp hands.
• Keep the appliance under constant supervision while in use. Keep an eye on
children.
• The appliance contains sharp parts - keep out of the reach of children.
• Use only accessories supplied with the appliance or those recommended by the
manufacturer.
WARNING: When mixing hot liquids/foods excess pressure may build up inside the
blender, and this could make the lid come off and the contents splash out.
We therefore recommend that you avoid mixing excessively hot foods and that you
only put very small quantities of hot liquids or foods into the blender.
Use
• Always place the appliance on a dry, level and firm surface well away from any
edges.
• Only turn on the appliance when:
o the blender glass with lid has been attached and contains liquid and/or
food, or
o when the centrifuge bowl, base, lid and fruit pulp holder are attached and the
locking mechanism is locked in a vertical position on the lid.
• Do not leave the appliance running nonstop for more than 2 minutes at a time.
If the appliance has been running for 2 minutes, allow it to cool down for 2
minutes before you use it again.
• Do not use the appliance if the centrifuge bowl is damaged or the lid is cracked
or damaged in any way.
• NEVER use your fingers, kitchen utensils or similar to push ingredients down the
feed tube! Use the accompanying tamper.
• NEVER stick fingers or other objects in the spout.
• NEVER touch the moving parts of the appliance until it has come to a complete
stop.
• Never pour boiling liquid or very hot food into the blender glass. Make sure that
the food has a sufficiently low temperature to avoid burning/scalding in case of
skin contact.
• Never add liquid or other food above the “MAX 100 ml” mark on the blender
glass.
• Do not use the blender glass if it is cracked or damaged in any way.
• Never put tools or your hands into the blender glass while the appliance is
switched on. Please note that the blade may still rotate for a while after you
switch the appliance off.
• Be careful not to touch the sharp edges of the blades during use and cleaning!
Cord and plug
• Do not let the cord hang out over the edge of the work surface.
• Check that it is not possible to pull or trip over the cord or any extension cord.
• Keep the cord and appliance away from heat sources, hot objects and naked
flames.
• Remove the plug from the socket before removing the lid from the appliance,
before cleaning, or when the appliance is not in use. Avoid pulling the cord when
removing the plug from the socket. Instead, hold the plug.
• Ensure that the cord is fully extended.
• The cord must not be twisted or wound around the appliance.
• Check regularly that neither cord nor plug is damaged and do not use if they are,
or if the appliance has been dropped or damaged in any other way.
• If the appliance, cord or plug have been damaged, have them inspected and
if necessary repaired by an authorised repair engineer. Never try to repair the
appliance yourself. Please contact the store where you bought the appliance for
repairs under guarantee. Unauthorised repairs or modifications to the appliance
will invalidate the guarantee.
KEY TO MAIN COMPONENTS OF THE APPLIANCE
1. Tamper
2. Fruit pulp holder
. Drive shaft
4. Motor section
5. Spout cover
6. Locking mechanism
7. Blender glass lid
8. Cap
9. Blender glass with scale
10. Blade
11. Spout
12. Base
1. On/off button
14. Centrifuge bowl
15. Container for skimming
of juice
16. Funnel
17. Juice extractor lid
PRIOR TO FIRST USE
Before using for the first time, or after prolonged storage without use, wash any
parts that will come into contact with food.
USING THE APPLIANCE
Preparing the juice extractor
1. Place the motor section (4) on a level surface, e.g. a kitchen counter, and make
sure it is standing firmly on the four suction cups underneath.
2. Attach the fruit pulp holder (2) by inserting the tab on the holder into the hole on
the one side of the motor section. Press until you hear a click.
. Place the base (12) on the motor section with the spout (11) facing the side
where the fruit pulp holder is attached.
4. Carefully lock the centrifuge bowl (14) onto the base.
o Be careful not to touch the sharp parts in the bottom of the centrifuge bowl.
o Press the centrifuge bowl into the base as far as it goes and you hear a click.
o Make sure that the centrifuge bowl doesn't sit too loosely on the base and
that it rotates evenly.
5. Place the juice extractor lid (17) on the appliance so that it covers both the
fruit pulp holder and the base with the centrifuge bowl. Make sure the lid is not
askew.
6. Pull the locking mechanism (6) into vertical position and press it into position
over the tabs on the lid until the lid locks into place. The lock mechanism makes
a clicking sound when this is done correctly.
7. Fit the cap (5) over the funnel by holding it against the side of the appliance with
the small end facing upwards and press until it clicks into place.
8. Place a glass, bowl or other suitable container under the spout.
9. If required, use the supplied container for skimming of juice (15). This container
has a dividing plate that separates the foam from the juice when you pour the
juice into a glass.
10. The appliance is now ready for use.
Using the juice extractor
1. Plug in and switch on the power.
2. Switch on the appliance by turning the on/off button (1) to "I".
. Feed the selected fruits and/or vegetables into the appliance through the funnel
(16) a little at a time, pushing them down using the tamper (1).
o Hold the tamper so that the groove fits correctly into the funnel.
o Long vegetables such as carrots should be fed into the funnel pointy end
first.
o Press the fruits and/or vegetables gently with the funnel. Too much presser
reduces the amount of juice extracted and can damage the appliance.
o Stop the appliance before removing the tamper to add more fruit/vegetables
in order to avoid splashes.
o Keep an eye on the fruit pulp holder and stop juicing before the holder
becomes too full. Take care that the container under the funnel does not
overflow.
4. Always turn off the power by turning the On/Off button to the "0" position before
removing the lid.
UK