Midland Radio OLYMPIANTM SERIES MO-4128 - Manual (Page 16)

Olympian ™ Series Mobile Radio User’s Guide
16 © 2007, Midland Radio Corporation http://www.midlandradio.com
Priority Select Scan
If channel select priority scan has been programmed by your
dealer or communications coordinator, the channel selected
when scan is turned on will be assigned as the priority channel.
Operation will otherwise follow the priority channel scan
conventions.
Transmitting While in Scan Mode
If PTT is pressed while the radio is in scan mode, your dealer or
communications coordinator may have programmed one of the
following options for the transmit channel:
1.
When PTT is pressed, the radio will generate an error beep
because your dealer or communications coordinator has
programmed the radio to not allow transmission while the
radio is in scan mode.
2.
When PTT is pressed, the radio will switch to and transmit
on the priority 1 channel, priority 2 channel or other dealer
programmed channel regardless of the current receive state.
This mode may be referred to as priority only transmit.
3.
If the radio has stopped on a channel, or the scan hang
timer
is active, the radio will transmit on the scan stop
channel when you press PTT. If you press PTT, while the
radio is scanning channels, the radio will switch to and
transmit on the priority 1 channel, priority 2 channel or other
dealer programmed channel. This mode may be referred to
as (priority) talkback transmit.
Editing Your Scan List
One of the advanced features of your Olympian™ mobile radio is
the ability to add channels and banks of channels to your scan
list. Of course, you may also delete channels and banks of
channels from your scan list. These changes are saved in radio
EEPROM and are not temporary like nuisance channel delete.
The channels in your radio may be organized in banks and each
bank may be selected for scan. Then within each bank, each
individual channel may be selected for scan. To scan a channel,