Mobi Technologies 70061 - Manual (Page 7)

INSTALLATION & SET UP
Installing Batteries
Your MobiCam AV can be powered by either using the supplied
AC power adaptors or batteries.
Using Batteries:
a) Remove the battery door (12, 26) at the bottom/ back of each
unit by loosening the child-safe screw (14, 25) and sliding the
cover downward to release.
b) Both units use 1.5 volt AA size batteries. Always use batteries of
the same brand and age (alkaline recommended). Insert 4 AA
batteries into the camera and 6 AA batteries into the monitor.
c) Replace the covers by aligning the tabs with the tab holes and
tightening the child-safe screws.
CAUTION: Remove batteries immediately once they run out of
power and dispose of them properly. Do not use batteries while
using the AC adaptor for extended periods of time as this might
cause battery leakage.
Using AC Adaptors:
a) Insert the AC adaptor into the DC Jack (9, 23) of either unit (The
AC adaptors are the same for both the Camera and Monitor).
b) Plug the AC adaptor plug into a standard AC power outlet.
5 6