McIntosh MT10 - Manual (Page 12)

12
How to Connect the Turntable
How to Connect the Turntable
McIntosh Preamplifier
1. Connect a Power Control Cable from the MT10 POW-
ER CONTROL REMOTE IN to the POWER CON-
TROL ACC Output jack of a McIntosh Preamplifier or
A/V Control Center.
2. Optionally, connect a Power Control Cable from the
MT10 POWER CONTROL REMOTE OUT to the
POWER CONTROL IN jack of a McIntosh source
component.
3. Connect a wire from the MT10 GND (Ground) Post to
the GND (Ground) post on the McIntosh Preamplifier
or A/V Control Center.
4. Connect Audio Cables from the MT10 OUT L and R
jacks to the MC Inputs on a McIntosh Preamplifier or
A/V Control Center.
Note: The MCC10 is a high output Moving Coil Car-
tridge and is supplied with the MT10 Turntable.
When connected to a Phono Input (MM [Mov-
ing Magnet]) on a Preamplifier or A/V Control
Center, it should produce satisfactory volume
level. If additional volume level is desired, an
in-line Pre-Preamplifier or step up transformer
may be added. Contact your McIntosh Dealer for
additional information and assistance.
5. Connect the supplied external Power Supply to the
MT10 DC IN 24V socket and the Power Supply to a
live AC outlet.
MT10
Power
Supply