MACKIE PPM1012 User Manual
Ppm1012
Advertising
Table of contents
Document Outline
- Front Cover
- Important Safety Instructions
- Read This Page!
- Introduction
- CONTENTS
- Hookup Diagrams
- PPM1012 Features
- Rear Panel
- Connection Section
- 6. MONO LINE INPUTS (Ch. 1 to 6)
- 7. LINE/INSTRUMENT INPUTS (Ch. 7 and 8)
- 8. STEREO LINE INPUTS (Ch. 9/10 and 11/12)
- 9. INSERT (Ch. 1 to 8)
- 10. MON SEND 1 and MON SEND 2
- 11. FX SEND 1 and FX SEND 2
- 12. FX RTN 1 and FX RTN 2
- 13. TAPE INPUTS
- 14. TAPE OUTPUTS
- 15. MAIN INSERTS
- 16. MAIN OUTPUTS
- 17. MAIN MONO OUTPUT
- 18. HEADPHONE OUTPUT
- 19. LEVEL
- 20. FX FOOTSWITCH CONNECTOR
- 21. BNC LAMP CONNECTION
- 22. LUNCH-TIME DECOUPLER
- Channel Controls
- 23. GAIN CONTROL
- 24. LOW CUT (Channels 1–8 only)
- 25. COMPRESSOR (Channels 1–6 only)
- 26. HI-Z SWITCH (Ch. 7 and 8 only)
- 27. HIGH EQ
- 28. MID EQ LEVEL (Ch. 1 to 8)
- 29. MID EQ FREQUENCY (Ch. 1 to 8)
- 30. HIGH MID EQ LEVEL (Ch. 9/10 and 11/12)
- 31. LOW MID EQ LEVEL (Ch. 9/10 and 11/12)
- 32. LOW EQ
- 33. MON 1 AUX SEND and 34. MON 2 AUX SEND
- 35. FX1 AUX SEND and 36. FX2 AUX SEND
- 37. PAN
- 38. MUTE switch and LED
- 39. –20, 0, +10, OL CHANNEL METER LEDs
- 40. CHANNEL FADER
- 41. SOLO
- 42. POWER LED
- Master Controls
- 43. 48V PHANTOM SWITCH
- 44. MAIN EQUALIZER
- 45. MON 1 EQUALIZER
- 46. MAIN EQ ASSIGN
- 47. POWER AMP LIMITER LEDs
- 48. MAIN MIX METERS
- 49. RUDE SOLO LIGHT
- 50. PRECISION PASSIVE EQ
- 51. BREAK SWITCH and LED
- 52. TAPE IN
- 53. POWER AMP MODE SWITCH
- 54. LPF (Low-Pass-Filter)
- 55. MONO OUT
- 56. FX 1 TO MON 1 and FX 1 TO MON 2
- 57. FX RTN 1 FADER and FX RTN 2 FADER
- 58. MONITOR 1 FADER and MONITOR 2 FADER
- 59. MAIN FADER
- Stereo Effects Processor
- Appendix A: Service Information
- Appendix B: Connections
- Appendix C: Technical Information
- Appendix D: Table of Effects Presets
- PPM1012 Limited Warranty
- Rear Cover