MACKIE 1402-VLZPRO - Manual (Page 15)

15
DIRECT OUT WITH SIGNAL
INTERRUPTION TO MASTER
INSERT ALL THE WAY IN TO
THE "SECOND CLICK"
MONO PLUG
TIP OUT TO EFFECTS DEVICE
RING RETURN FROM EFFECTS
STEREO PLUG
FOR USE AS AN EFFECTS LOOP
(TIP = SEND, RING = RETURN)
R L
CONTROL
ROOM
MIC
+4
BAL/UNBAL
MAIN
OUTPUT
LEVEL
MAIN
LEFT
MAIN
RIGHT
POWER
ON
PHANTOM
ON
120 VAC 50/60 Hz 25W
500mA/250V SLO-BLO
TO REDUCE THE RISK OF
FIRE REPLACE WITH SAME
TYPE FUSE AND RATING
CAUTION:
BALANCED BALANCED
THE FOLLOWING ARE TRADEMARKS OR REG
1402-VLZPRO
14-CHANNEL MIC/LINE MIXER
WITH PREMIUM XDR TM MIC PREAMPLIFIERS
MAIN OUTPUT LEVEL
Engaging this switch pads the balanced
XLR MAIN OUTPUTS by 30dB, so you can feed
the microphone input of, say, another mixer.
Perfect for sending a submix to another mic
level input in boardroom or conference room
applications.
You can safely plug this output into an input
that provides 48V phantom power.
1 ⁄
4
" MAIN OUTPUTS
These 1 ⁄ 4 " jacks are balanced outputs ca-
pable of delivering 22dBu into a 600 ohm
balanced or unbalanced load. (Okay, we admit
it, that was a pretty technical sentence. See
the Glossary and Connections appendices if
you want to decode it.)
To learn how signals are routed to these 1 ⁄ 4 "
outputs: .
To use these outputs to drive balanced in-
puts, connect 1 ⁄ 4 " TRS (Tip-Ring-Sleeve)
phone plugs like this:
For most music recording and PA applica-
tions, unbalanced lines are perfectly
acceptable. To use these outputs to drive un-
balanced inputs, connect
1 ⁄ 4 " TS (Tip-Sleeve)
phone plugs like this:
Tip = + (hot)
Sleeve = Ground
TAPE OUTPUT
These unbalanced RCA connections tap the
MAIN OUTPUTS to make simultaneous record-
ing and PA work more convenient. Connect
these to your recorder’s inputs.
To learn how
signals are routed to these outputs: .
MONO OUT: If you want to feed a mono
signal to your tape deck or other device, simply
use an RCA Y-cord to combine these outputs
(Radio Shack
® #274-511, for instance). Do not
attempt this with any other outputs on the
1402-VLZ
PRO.
Tip = + (hot)
Ring = – (cold)
Sleeve = Ground
SLEEVE
TIP SLEEVE
TIP
RING
RING
TIP
SLEEVE RING
SLEEVE
TIP
TIP SLEEVE
TIP
SLEEVE
TIP SLEEVE TIP SLEEVE