Maretron INTERNET PROTOCOL GATEWAY IPG100 - Manual (Page 14)

IPG100 User’s Manual
Page 10 Revision 1.2
NOTE:
icense Keys. The “old” key has a plastic case and carries a
l. The “new” key has a gray metal case and has the Maretron
you previously purchased, please contact Maretron sales to upgrade it to a “new” key so
that you can use it with the IPG100.
There are two types of Hardware L
“SafeNet Sentinel” logo on the labe
logo etched into the metal case.
“Old” Key: “New” Key:
The “new” key is required to use with the IPG100. The “new” key will also work with the
N2KServer
®
PC software (version 3.0.4 and later). If you have an “old” key from a version of
N2KView
®
2.5 Indicators
The IPG100 has three green LED indicators on its top surface:
NMEA 2000: This light will be red for several seconds after powerup while the IPG100 is
initializing itself. Once this process is complete, this light will be lit a steady
green to indicate that the main processor is active. The light will blink on and off
to indicate data being transferred over the NMEA 2000
®
connection. If this light
is lit red after the initialization has completed, it indicates that a problem has
been detected.
LAN:
This light will be on steadily to indicate that there is an active link connection
betwee
l b ink on and off to
indicate the light is off, then
ult
fer to the corresponding
n the IPG100 and the attached device. The light wil
data being transferred over the LAN connection. If
l
there is no active link connection.
to re
een 0 and 252. The default device instance is 0
USB:
This light will be on to indicate that the USB port is active.
3 Configuring the IPG100
The IPG100 has several configurable parameters, which are shown below including the defa
values. If you are not using the default values, then you will need
section for configuring the IPG100 appropriately. You may configure the IPG100 using a
Maretron DSM250 display or Maretron N2KAnalyzer
®
software.
3.1 Advanced Configuration
3.1.1 Device Instance
Program this parameter to the desired instance number for this device. You can program this
parameter to any value betw