Connecting a dtv receiver, continued, Dtv receiver with rgb video connections, Dtv receiver tv back pane – MITSUBISHI ELECTRIC WT - 42313 User Manual
Page 20: G (green) = y/g, B (blue) = pb/b, Figure 13)
20
21
Connecting a DTV Receiver, continued
DTV Receiver with RGB Video
Connections
(Figure 13)
1. Connect the outside antenna, cable, or satellite to
ANT or SATELLITE IN on the DTV receiver
(see your DTV receiver owner’s guide for
instructions and cable compatibility).
2. If your DTV receiver has a built-in terrestrial tuner,
connect the incoming terrestrial antenna to ANT
on the DTV receiver. If your DTV receiver does
not have a built-in terrestrial tuner, this TV will
only be able to provide an analog signal through
Ant-A on the TV back panel.
3. Connect the RGB cables from the DTV receiver
to the TV back panel as listed below (if your DTV
receiver uses BNC-type cables, use the adaptors
shown in Figure 11, page 19):
DTV Receiver
TV Back Pane
l
G (green)
=
Y/G
B (blue)
=
Pb/B
R (red)
=
Pr/R
4. If the DTV receiver has outputs for H and V sync,
connect as listed below (DO NOT connect if
DTV receiver uses “Sync on Green”):
H (horizontal sync)
=
H
V (vertical sync)
=
V
5. Connect the L (left) and R (right) audio cables
from the DTV receiver to DTV AUDIO on the
TV back panel.
6. To utilize the benefits of a digital A/V receiver,
connect your DTV receiver’s digital audio out to
a digital input on your digital A/V receiver.
You may need to setup the DTV (See Input
Assignment, page 35) to RGB.
Figure 13. Connecting the DTV receiver with RGB
video connections.
Y
G
Pb
B
P r
R
V
H
DTV
(Y PbPr/ GBRH V )
480 i / 480P /1080 i
COMPONENT
480 i / 480P/ 1080i
2
1
Y
P r
Pb
AUDIO -
RIGHT
L E FT /
( MONO)
AUDIO -
I N P U T
2
1
AUDIO-
R IGH T
AUDIO-
LEFT /
(MONO)
V I D EO
S-VIDEO
MONITOR
OUT
AN T - A
A N T- B
LO O P
OUT
V
H
Y
G
Pb
B
P r
R
TV Back Panel (section detail)
DTV Receiver (witH RGB connections)
AUDIO
L
R
V
G
R
B
S-VIDEO
VCR
CONTROL
PHONE JACK
RF
REMOTE
OUT TO TV
CH 3
CH 4
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
DIGITAL
AUDIO OUT
White
Red
5
Incoming Antenna,
or Cable.
2
2
1
1
SATELLITE IN
IN FROM ANT
or
to antenna,
cable or satellite
3
3
3
3
3
3
5
5
5
White
Red
H
4
4
4
4
Note: The TV back panel and connections shown here are for reference only and may vary by model.
See Appendix B, page 65 for component video
signal compatibility information.
For digital audio connections, see your DTV
receiver and A/V receiver Owner’s Guides.