Mitel PAP2T - Manual (Page 11)

7 Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu
Overview
Internet Phone Adapter with 2 Ports for Voice-over-IP
Chapter 4: Using the Phone Adapter’s Interactive Voice
Response Menu
Overview
You may need to manually configure the Phone Adapter by entering the settings provided by your Internet phone
service provider. This chapter explains how to use the Interactive Voice Response Menu to configure the Phone
Adapter’s network settings. You will use the phone’s keypad to enter your commands and select choices, and the
Phone Adapter will respond with voice responses.
Accessing the Interactive Voice Response Menu
1. Use a telephone connected to the PHONE 1 or PHONE 2 port of the Phone Adapter.
2. Press the * (star) key four times.
3. Wait until you hear “Configuration menu. Please enter option followed by the # (pound) key or hang up
to exit.”
4. Refer to the table on page 8 for a list of actions, commands, menu choices, and descriptions. After you select
an option, press the # (pound) key. To exit the menu, hang up the telephone.
NOTE: If your Internet phone service provider sent you the Phone Adapter, then it may be
pre-configured for you, and you may not need to change any settings. Refer to the instructions
provided by your service provider for more information.
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030