Motorola SURFboard SBV6220 - Manual (Page 15)

B
Installing the Modem • Installing the Battery
SBV6220 DOCSIS 3.0 Digital Voice Modem • Installation Guide
548415-001-a 7
3
Installing the Modem
To install and configure the SBV6220 Digital Voice Modem for a single PC with Microsoft
Windows, do the following:
•
Install the battery.
•
Connect the modem to your computer and telephone.
•
Set up Internet access and verify the IP address for your computer.
CAUTION: This product is for indoor use only. Do not route the Ethernet and telephone cables outside of the
building. Exposure of the cables to lightning could create a safety hazard and damage the product.
Installing the Battery
First, install the battery in the modem before installing any other components.
Before starting the battery installation, refer to
2
Safety Requirements for the SBV6220
Lithium-Ion Battery for information.
Note: The battery may take up to 12 hours for a full charge.
1. To remove the battery cover, place the modem on its side (LEDs facing up) and
press down on the two locking tabs.
2. Slide the battery into the battery compartment until it is fully seated.
3. Replace the battery cover.