Mesa/Boogie OOGIEBMESA - Manual (Page 10)

PAGE 5
TOGGLE SWITCHES:
ON ON
POWER STANDBY
RHYTHM
CONTOUR
F
T
S
W
L
E
A
D
RHYTHM / LEAD / CONTOUR: Use this toggle to select one of the three Modes - RHYTHM, LEAD or CONTOUR. This
toggle can also take the place of the remote footswitch when there isn’t one handy.
Perfect for set breaks...this toggle switch also serves an even more important purpose. In the STANDBY
position the tubes are at idle so that during power up they may warm up before being put
to use. Before the Power is switched on, make sure the STANDBY switch is in the
STANDBY position. Wait at least 30 seconds and then switch the STANDBY to the
"ON" position. This helps in preventing tube problems and increases their toneful life
substantially.
ON ON
POWER STANDBY
RHYTHM
CONTOUR
F
T
S
W
L
E
A
D
ON / STANDBY:
This is the A.C.’s ( Alternating Current ) main fuse and provides protection from outside A.C. fluctuations, as well as
power tube failure damage. Should the fuse blow, replace it with the same rating in a slo-blo type package. The
domestic U.S. version requires a 1 amp slo-blo fuse. A power tube short or failure is often the cause of a blown
fuse...Follow the cold start procedure mentioned in the ON / STANDBY switch section and watch the power
tubes as you turn the STANDBY to the ON position. If a power tube is going bad or is arcing you will see it! Turn the
STANDBY Switch to STANDBY immediately and replace the faulty power tube and the fuse if necessary. If you see nothing
abnormal as you lift the STANDBY, it is possible that a power tube shorted temporarily and blew the fuse. If this is the case it may
work again normally. To be extra safe you may want to replace all power tubes in the "shotgun" troubleshooting tradition and save
the replaced set as spares. Don’t forget to carry along a few extra fuses to your gigs, they could be worth their weight in
FUSE:
1/2 A
FUSE
1A SB
RETURN SEND
FX MIX
0% % 100
HANDBUILT IN PETALUMA, CALIFORNIA.
D YNA - W ATT P OWER TM
8 OHM 4 OHM 4 OHM
SPEAKERS
1A SB
FUSE
A 1
2
SILENT RECORDING
MUTE SPKR ON
RECORD / PHONES
REAR PANEL:
SUBWAY ROCKET
PRE-AMP PATENT
4,701.957
POWER: This switch delivers the A.C. power to the SUBWAY ROCKET. Make sure the unit is grounded (all three
terminals of the A.C. power cord must be connected whenever possible to avoid injury to
the user as well as to the unit) and that the proper voltage is present. Follow the cold start
procedure described in the ON / STANDBY section above when powering up your
ROCKET.
ON ON
POWER STANDBY
RHYTHM
CONTOUR
F
T
S
W
L
E
A
D