Mobi Technologies MOBICAM 70062 - Manual (Page 11)

Monitor Operation & Installation
NOTE: For best performance it is recommended to keep units at least 7-8 feet
away from other wireless devices.
Power ON/OFF
To turn on the monitor unit, slide the LCD Power On/Off switch (5), located on
the right side of the monitor, to the “ON” position.
LCD Off
When the LCD Power On/Off switch (5) is set to the center, LCD OFF position,
the unit can be used as an audio-only monitor. This feature enables the monitor
to use less power and remain operational, but without using the LCD screen.
The monitor screen image will return with a clear picture whenever the switch is
moved to the “ON” position.
Channel Selection Mode
The monitor allows you to monitor up to 3 cameras (additional cameras sold
separately). Select the desired channel, either A, B, or C, (11). Both the Moni-
tor and Camera will be initially set to channel A. Your monitor will display the
selected channel at the top left corner of the screen.
NOTE: If the picture continues to switch between cameras, the Automatic Chan-
nel Scan mode is activated.
Automatic Channel Scan
This option allows the Monitor unit to scan through all 3 channels automatically
and stops at each channel for about 5-7 seconds. Slide the Channel Selector
switch (11) to the “SCAN” position to activate this feature. The receiver will
automatically skip channels that are not linked to a camera.
Channel Matching (Pairing & Un-pairing)
This product is designed to allow monitoring different areas with up to 3 cam-
eras (Channel A, B, or C). The Monitor and Camera will be initially set on chan-
nel A. If you need to use another Camera for monitoring you need to “pair” the
new camera with a new Channel on the monitor. You can disable this feature by
selecting only the camera you want to use by using the Channel Selector (11).
To Pair A New Camera
• Turn OFF both the Monitor and the NEW Camera. Place them not more than
10 feet apart.
• Turn ON the NEW Camera. Press the hidden PAIRING button through the
small hole at the bottom of the Camera by using a pin (19). The Night Light
will start blinking rapidly to indicate pairing mode.
9