McIntosh MC1201 - Manual (Page 7)

7
UNBALANCED INPUT
for an audio cable from a
preamplifier or control cen-
ter audio output
CIRCUIT BREAKER
Press to reset if the am-
plifier will not power
up
Rear Panel Connections and Switch
Connect the
MC1201 power
cord to a live AC
outlet. Refer to in-
formation on the
back panel to deter-
mine the correct
voltage
BALANCED INPUT for an au-
dio cable from a preamplifier or
control center audio output
POWER CONTROL IN receives turn On/
Off signals from a McIntosh component and
the POWER CONTROL OUT sends a turn
On/Off signal to the next McIntosh compo-
nent
OUTPUT Connections
for 4 ohm loudspeaker
INPUT MODE
switch selects
balanced or
unbalanced
input
OUTPUT Connections
for 8 ohm loudspeaker
Caution: The Loudspeaker Negative Connections are above chassis
ground. Do not combine any connections together, ground
them or connect with another MC1201.
OUTPUT Connections
for 2 ohm loudspeaker